How to Replace the Brake Interlock Switch on a Riding Lawn Mower

This DIY riding mower repair guide gives step-by-step instructions for replacing the brake interlock switch on a riding lawn mower. When working correctly, this safety switch keeps the engine from starting if your foot isn’t pressing down on the brake or if the parking brake isn’t set. If the switch breaks, it won’t let current reach the starter solenoid coil even though the brake is on, and the engine won’t start. If the solenoid doesn’t click when you turn the ignition key, the brake interlock switch is most likely at fault. Watch this lawn tractor troubleshooting video to learn how to test the starting system and brake interlock switch. Replace the brake interlock switch with a manufacturer-approved replacement part.

Repair difficulty:
     
Time required:

Less than 30 min.

Parts Required

  • Brake interlock switch
Find This Part

Tools Required

  • Wrench set
  • Work gloves

Before you begin

Let the engine cool.

Park the tractor on a level surface, but don’t set the parking brake so that you’ll be able to remove the brake interlock switch.

Wear work gloves to protect your hands.

Instructions

 Warning: Undertaking repairs or maintenance to appliances or power equipment can be hazardous. Should you choose to undertake repairs or maintenance, you are assuming the risk of injury to your person or property. In an effort to reduce the risk, use the proper tools and safety equipment noted in the applicable guide and follow all instructions. Do not proceed until you are confident that you understand all of the steps and are capable of completing the repair. Some repairs or maintenance, however, should only be performed by a qualified technician.

How to Replace a Brake Interlock Switch on a Riding Lawn Mower

Step 1: Disconnect the battery

Turn the ignition switch off and remove the key.

Lift the seat.

Remove the bolt connecting the negative cable to the battery and tuck the cable away from the battery so it doesn’t touch the battery post.

Step 2: Release the steering plate

Lower the mower deck to its lowest position.

Remove the left rear steering plate mounting bolt.

Remove the left front steering plate mounting bolt and the upstop bracket.

Step 3: Remove the brake interlock switch

Lift the hood.

Remove the lower dash fastener and pull off the lower dash.

Remove the wire harness from the brake interlock switch.

Squeeze the brake interlock switch mounting tabs and push the switch down to release the switch from the tractor frame.

Push straight down on the brake pedal to lower the steering plate and remove the brake interlock switch.

 Tip: Remove the fuel tank and rest it on top of the engine if you need more room.

Step 4: Install the new brake interlock switch

Position the new brake interlock switch under the tractor frame.

Push straight down on the brake pedal to lower the steering plate and snap the new brake interlock switch onto the tractor frame.

Connect the wire harness to the new brake interlock switch.

Reinstall the lower dash and secure it with the fastener.

Lower the hood.

Step 5: Reinstall the steering plate

Position the upstop bracket on the frame and reinstall the left front mounting bolt in the steering plate.

Reinstall the left rear mounting bolt in the steering plate.

Step 6: Reconnect the battery

Set the parking brake.

Reconnect the negative cable to the negative battery terminal.

Lower the seat.

Leave a Reply

Your email address will not be published. Required fields are marked *